Metal coil slitting machine on the production floor

Slitting yield depends on the width pattern and on how much accepted material leaves the operation. A width calculation is a useful starting point, but it is not the same as a production yield guarantee. Trim, unusable ends, inspection rejection and the actual order mix must be recorded separately.

Calculate geometric width utilization

For a simple pattern, add the widths of all planned good strips and divide by incoming coil width. For example, three 300 mm strips from a 1,000 mm coil use 900 mm of width: geometric width utilization is 90%.

The remaining 100 mm is unallocated width in this example. It must be evaluated against the required edge trim and the approved tooling pattern; it is not automatically another saleable strip. This arithmetic example is not a proposed machine setup.

Planning field Example Interpretation
Incoming width 1,000 mm Starting width for the pattern
Requested strips 3 × 300 mm 900 mm of planned good width
Unallocated width 100 mm Must accommodate trim and any planned remainder
Geometric width utilization 90% Width ratio, before other production losses

Actual process planning must confirm usable incoming width, edge condition, tooling and finished-strip tolerances. Do not import assumptions about kerf or trim from a different cutting method.

Separate planned utilization from accepted yield

Mass-based accepted yield compares accepted output mass with input mass using a defined accounting boundary. Decide whether trim, retained remnant material, setup samples and rejected coils are included in each category.

Avoid comparing one order’s width utilization with another order’s mass yield as though they were the same measure. Keep the unit and boundary visible on production reports. If a calculation uses estimated mass, label it as an estimate rather than a measured result.

Match the pattern to real orders

A mathematically efficient pattern is only useful if its widths are required and acceptable. Check strip quantities, downstream batch needs, finished-coil weights and delivery sequencing. Producing surplus widths can improve a width ratio while creating unwanted stock.

Where several orders could share a parent coil, review their material grade, thickness and surface requirements together. Similar width does not make different grades or finishes interchangeable.

Track losses by cause

Record edge trim, head and tail loss, setup material and quality rejection separately where the plant’s measurement system permits. Link records to the coil, pattern and inspection results. A recurring quality loss requires a different response from an unavoidable remainder in a particular order pattern.

Use width and edge inspection to define accepted material. For equipment selection, provide the common strip patterns and finished-coil requirements through the slitting equipment page. No percentage saving is promised without a baseline and measured trial results.